2 d

Did a computer reset and crank?

- Exchange the fuel pump relay and the ASD relay with one of the other si?

Once it turns over it is fine. - Fuel pump should run and prime for 3-5 seconds. When I tried to start the Jeep up again No gauges were working but headlights, interior lights, stereo worked. When I first started to drive it the crank sensor went out on me. janinge bar stool Jeeps do not tolerate low voltage or poor grounds and the ECM/ECU may behave oddly until you remedy this. Sold '00 TJ, 4" lift, rusty's adjustable control arms, skyjacker shocks, rock krawler adj. When it comes to starting your car in cold weather, having a reliable battery is crucial. - A failed CPS/CKP may or may … 2010 JK Automatic. can't take it summrs I'm a handy guy and like to tinker but I can't figure this issue out. The CPS can stop working with no warning or symptoms and the engine will not run or the engine may randomly stall for no apparent reason. The CPS can stop working with no warning or symptoms and the engine will not run or the engine may randomly stall for no apparent reason. Regardless there's no way you should be receiving a full 12V of power to the crank sensor2 crank sensor connector wiring is as follows: C - White/black, 8V supply from PCM Oct 10, 2010 · Crank Position Sensors can have intermittent "thermal failure". If the battery is fully charged and your Jeep still doesn’t start, you should proceed to test the starter. dachshunds for sale in ct Remove, clean, and firmly reconnect all the wires and cables to the battery, starter, and alternator. ….

Post Opinion